Good morning, quick question I have an engraving that reads EdgeTech Instruments and I'm trying to use "Franklin Gothic italic bold 24 points" and when I do this the "m" does not shows up but other fonts everything shows up, does anyone knows why this happening.
Thanks,
Pedro Ortiz
Did you do a cut or a split line?
Chances are good that it just missed that contour, you should be able to edit the feature and select the contour for the "m".
todd
if you upload the file, we could take a look at it.
Hi Todd,
I did a cut and after your reply I tried the split-line and still did not work, I send you the file to you email was that ok, if not please let me know, "first time user to these Forums" . Any help would be greatly appreciated.
Thanks,
Pedro
Pedro,
You can just post the file to the forums, you will need to click on "Advanced Editor" to be able to attach a file.
todd
edit: The "Attach" link is in the lower right corner -
One is cut, one is split line - It could be the amount of text that you have in the sketch, or it could be another issue.
todd
