I cannot figure out how to extrude a cut to the center point of a rectangle i have attached the image below as you see the center stays in rectangle form any help would be appreciated on this, Thanks
Easy way is using loft feature
maybe to use draft
prt file att.
hope this helps- kelef
edit:- please forget all the before of this crap-
sorry misread your lead post
see the second att.file jusmessin.SLDPRT
to get to a point, the draft angles on the short and long sides would be different. as mentioned, that can be achieved with a loft cut.
if a the drafted edges meeting at a ling in the center is acceptable, change your end condition to up to next.
the OP states "cut to the center point"
but the jpg shows a consistent angle to me
maybe we need the drawing/original design intent
would be clearer for a solution
actually if I read the original post correctley
I wouldn't be posting crap - that was the problem
please except apologies for being a numb nuts
Retrieving data ...