AnsweredAssumed Answered

Weldment list Mass weight not same as Weldment Table

Question asked by Paul Rymal on Aug 2, 2017
Latest reply on Aug 3, 2017 by Paul Rymal

Not sure whats going on here but I cant seem to correct this problem. When I set up a custom property in the Weldment cut list of the part everything shows right on the properties list however once I insert the weldment cutlist table into the dwg the weights are showing hundreds times heavier?

Any ideas! Ive attached pdfs to show the conflict. Using Sworks 2017 SP-2

Thanks

Paul

Outcomes