11 Replies Latest reply on Aug 28, 2018 10:11 AM by Scott M.

    BOM Part Configuration Grouping

    Peter Kennedy

      I have a multiple body part that I'm using in an assembly. I have two separate configurations of each other as it just a mirror. The two parts being used are Angle and Flat Bar. The flat bar is the same in both configurations however the angle is different.

       

      In the assembly I require one of each, now when I make the BOM I know I can choose between the following three options:

      However this is for the complete table, is there a way to pick and choose which items are combined in the BOM?

      Ideally I would have items 10 and 12 only be 1 line and have 11 and 13 separate like they currently are: