AnsweredAssumed Answered

Tubing not showing after completing Routing

Question asked by Justin Dehetre on Jul 31, 2017
Latest reply on Aug 25, 2017 by Xu Jun

I searched and found nothing like what I am experiencing.

When I finish a Tube Route, a part is created in the Assembly Tree, and I can edit it, remove it, etc, I just can't actually SEE it.

See attached picture for what I mean. Could this be a graphics card issue? My coworker can open the same model and see the tubes just fine. His computer is actually 3 years older than mine and has a different graphics card, though I'm not sure what it is.Tube not showing.jpg

Outcomes