0 Replies Latest reply on Jul 28, 2017 9:01 PM by Rob Haman

    SW users with ProNest Module?

    Rob Haman

      Hello,

      Our company recently purchased a new plasma table that uses ProNest. We opted for the Solidworks interface module in the hope we could avoid creating dxf's. I have basic parts, scribes, and marks working quite well, it's when a part has a beveled edge that's causing issues.

      I have ProNest recognizing there is a bevel on the plate but not the correct bevel.

       

      Just looking for someone who has maybe been through this.

       

      Thank You.