Hi.
I have a few cable routes that I have set up and assigned the appropriate cable to and now suddenly they are grey in the main view as shown in the image below.
Now when I go into edit the route the colour is visible so it is assigned to it, shown below.
Why when I go back to the main view is it grey. I don't want to have to delete them all.
Thanks,
Mark.
It looks to me like they aren't gray, but have been set to transparent.
Transparency has not been enabled.
I have done all the cables the same way so the colours should be visible. Obviously some parameter is set or unset but cant find out why.
Maybe there are some Assembly appearance over-rides. Click on the little arrow at the top right corner of the tree to show the appearance columns. In the example below the one component has had the color changed to the bright pink in the assembly.
Mark,
As Glenn Schroeder says, they certainly look as though they have transparency turned on. I had this recently & as I have select through transparency turned on I was unable to select the cable when I rolled my cursor over it (which proves it was transparent). I held down the Shift key & selected the cable in the graphics window & the pop up window that you show above came up showing that transparency was turned on for some reason. I toggled it off & all was solid again as it should of been.
I am able to select the routes so transparency is not set. Also you can see in the image below that all the cables have the same settings.
Mark,
Have you tried expanding the Harness assembly? Mine didn't show as transparent at that level but when I dug down into the tree the final part in the final folder had transparency on it.
Great stuff. It had one of these double triangle thingys which was the culprit. One other thing in some of the routes the cable and the route are separate. Now if I move one of the spline points slightly it fixes it but is there a better way for the cable to match the route in the settings?
