AnsweredAssumed Answered

How do you change the wire routing from one Cpoint to another?

Question asked by Wayne Blanchard on Jul 26, 2017
Latest reply on Jul 26, 2017 by Wayne Blanchard

I have a harness with several wires involved.  I need to change one of the wires on one of the connectors from its current location of Cpoint1 to its new location of Cpoint3.  I though it was as simple as editing the From/To table and reimporting. That does not seem to be the case. While in this case I could simply delete the harness and start again since it only has a few wires involved I would like to learn how to make the change if and when I have a much larger harness that would need updating. This particular model has been done in Sw2014.

Outcomes