AnsweredAssumed Answered

Midplane offset from sketch plane boss extrude

Question asked by Ed Hogan on Jul 25, 2017
Latest reply on Jul 26, 2017 by Ed Hogan

I'm attempting to do what I can only really refer to as a Midplane, Offset from Sketch Plane Boss-Extrude feature. Essentially, extruding a sketch (on the right plane) from the mid plane (equal distance on either side of the right plane) but also offset (equal gap on either side of the right plane). So I would end up with two bodies, symmetrical about the right plane. I'm aware I can use an extrude cut to punch the center out of a standard midplane extrude, but I would like to find a way to absorb this in one feature.

 

Thanks!

Outcomes