AnsweredAssumed Answered

multi radius sheet metal rolling with flats/flanges at end

Question asked by mike english on Jul 20, 2017
Latest reply on Jul 21, 2017 by mike english

The part below has multiple radii and two flat lengths at each end.  I'm having trouble getting the flat pattern.  It always has at least one item that can not be unbent. I originally made a sketch of the complete profile and then used 'base flange' and selected the sketch to create the sheet metal.  Then I did a profile of just the radius sections and added the straights as edge flanges.  Same results.  Any ideas?  I've attached the model Thanks!

 

3RM585107.JPG

Attachments

Outcomes