AnsweredAssumed Answered

help with mates

Question asked by Travis Guthrie on Jul 19, 2017
Latest reply on Jul 19, 2017 by Andy Sanders

So we are a die shop and we usually have to locate the parts in an assembly before start our die. So First why and I not check the draft of an assembly usually have to put my parts together offset my surfaces for the punch, then check the draft and I usually have to do this 2 to 3 times and see if its right, cause I see no way to check it before. We deal with almost all curved parts and using lines and points I can never seem to And an Angel in the  mate to help with the tip. These two parts need to be tipped by 2 degrees and I can not seem to find a way to do this

Attachments

Outcomes