4 Replies Latest reply on Jul 19, 2017 12:37 PM by Shea Pérez

    Change default circle parameter input from RADIUS to Diameter (simple please) SW 2016?

    Shea Pérez

      When I go to sketch a circle it gives me the option to enter in the radius and then hit enter. I know that I can input the diameter/2 but in previous versions of SW at my last job, the default was already set to enter the Diameter instead. I have scoured the menus and preferences to no avail, but I am sure that there must be some simple way of changing this...I have searched all over the net and found similar questions with answers that did not apply to my version of SW (2016).