AnsweredAssumed Answered

Drawing standard for sheet metal cross break?

Question asked by Swme Eng on Jul 17, 2017

Hello, one of my colleagues recently had a number of cross breaks bent the wrong direction. It raised the question of if there is a standard for calling out cross break directions in sheet metal parts. It seems that the down or up callout in SW is a bit confusing. It looks like there is an SPR for this, but man it would be nice for there to be a tool in solidworks that actually created the feature. The current tool just puts annotation lines, so there is no way to quickly create the geometry for show on drawings, or for checking interferences in assemblies.