I need to mirror the circle feature to the other side. When I select the feature from the FMT, the boss extrude3 shown as below after I hit green check. Don't know what happen.
Message was edited by: Chika Co
#1..."right plane" is not in the center of the part. (I created a plane5 using the bent tabs to generate"
#2...change Boss-Extrude3 to "up to next"
Can you share the Part?
zip file attached
Wow! Problem fix. Thank you. I always use "up to surface".
"Up to surface" works too. I believe your original model had "offset from surface" & a face/distance. this is partial reason to what threw off your original solution.
Oop! I found out my inside distance is a little wide than the actual model. I need to reduce 9.5mm from current dimension on sketch 1. When I changed my Boss extrude1 sketch (6.500), I got a rebuild error. I should have set my origin to the centerline of sketch1 to avoid this error. How do I fix my sketch so that it is symmetrical? Thank you
To Fix your error:
1.) Roll the model back to ease viewing
2.) in sketch1 decrease the size by the 9.5mm. (i just changed the dim to 6.125)
3.) Roll the model forward and verify the build on every step..
4.) When you get to Cut-Extrude2 it is not as it should be. a vertical line went wrong
5. Edit Sketch11(under Cut-Extrude2)
6. I believe this line should be vertical....(side question is methodology for the slot construction...very unusual)
7. Fillet error is gone...
To fix your symmetrical issue, because of the way you built the model, almost every feature would have to be fixed/altered.
I had exactly the same error with the hole cut out. It will be good for me to start the model all over for good practice. Thank you very much.
There are many ways to design/fix parts...this was only one..
..arrgghh... never mind, that did not work....and, looks like Cad Admin got you covered...
Once the model is fixed as i had described the "Geometry Pattern" would work too... and is a better option
Thanks Paul. This way works too. If I don't change the boss extrude3 to up to next, there is no hole cut out for two holes. I fixed my model now. Thank you all
If you wanted to add the other pattern into the second mirror, add Mirror1 to the feature window.
Thanks Cad Admin! I included mirror 1!
Retrieving data ...