AnsweredAssumed Answered

Loft/chamfer with splines

Question asked by Tom Verspeelt on Jul 4, 2017
Latest reply on Jul 5, 2017 by Dave Bear

I'm really puzzled on how to tackle this problem. What I basically need is a chamfer with a variable length/angle, but the Chamfer tool doesn't seem to be the feature to use in this case. I'm guessing a loft is the way to go, but that doesn't work either.


I want to make a raised edge on this part. There is a single line that is off-set from the face. I want the raised part to always follow a line that goes from the outside edge to the raised edge, perpendicular to the raised edge. I can do this manually for the straight part, but that only covers a small part of the design.



Any ideas on how to tackle this?