I have a part with multiple configurations because of different lengths. See attached. I have gotten it as far as getting the length of the part to show up in the qty by using a design table, but I would like a way to combine the qty's. I can't use part configurations grouping because of the way we do our fasteners. (one file multiple configs for the sizes, so I can't combine these.) Since I use the document name to show as a part number...the bom shows each part as a different line but it has the same part number. Our fasteners show the config names so the part numbers are different. Is there a way to combine these or a whole different way to go about this?

Getting the length value to show as qty is a little funny, combining these would be the second level of funny. In my past the second level of funniness for SW never works.

Thanks,
Cody