Not sure if this is an ok place to post this, but I haven't found anything about it online.
I'm designing a case with a lip groove lid that needs a click closure moulded into the part. Think of a kinder surprise egg.
The design is made of injection moulded ABS, and I'm curious if anyone has a resource for dimensions for these sort of click closures, for thicknesses and depths for moulding directly into the part.
Edited for clarity
Southco has always been my go to for latches.
Push to Close Latches - Southco
Thanks for the link, but I was talking about snap features moulded into the part.
Sorry for the confusion.
Retrieving data ...