AnsweredAssumed Answered

Circular pattern - SW2009 getting axis wrong

Question asked by Eric Snyder on Jan 7, 2009
Latest reply on Jan 7, 2009 by Eric Snyder
  • Comment • 1
I am trying to do this circular pattern. Attached is the preview. The features I am trying to pattern are one extruded cut and two fillets. The axis is in the center of the ring. As you can see the axis that the pattern is getting revolved is totally wrong.

Any ideas?
Eric Snyder
Eric Snyder Jan 7, 2009 4:17 PM
Correct Answer
I found the answer. I was using a centerline in a sketch for the axis. I added a reference geometry entity called an "axis" and used that for the axis. That worked.
See the reply in context

Attachments

No one else had this question

Outcomes