AnsweredAssumed Answered

Hi. I have drawn a channel pressing (in 2017) and want to put a chamfer on the ends. however if i flatten the part. it ether wont flatten or it removes a section where the bends are, is there any way around this?

Question asked by Des Bearham on Jun 28, 2017
Latest reply on Jun 28, 2017 by John Stoltzfus

Hi. I have drawn a channel pressing (in 2017) and want to put a chamfer on the ends. however if i flatten the part. it ether wont flatten or it removes a section where the bends are, is there any way around this?

Outcomes