Hey guys, i'm trying to make two semi-circle cut in this part but I always get an error of intersecting the centerline.
Anyone knows where is my fault?
Fernando,.. sketch semi circles from the center/revolve line.. (image attached)
A full circle will be self-intersecting when revolved through 360°
Change the sketch to have closed semi-circles and use one of the diameter lines as the rotation axis.
Do as Paul Salvador has suggested and make the circles be half-circles, or reduce the rotation of the cut to 180 degrees instead of 360 degrees.
.. or reduce the rotation of the cut to 180 degrees instead of 360 degrees.
Does this work for you Doug Seibel ?It doesn't work for me with SW17-SP3 nor in SW16-SP5
My bad...you are correct Kelvin Lamport, a 180 revolve still fails.
A side question to your post sorry.
I love the animated gif you have included, for me it is the best way to illustrate a problem/solution
Please can you explain the process of how you do this. Whenever I have tried, the forum rejects it.
Retrieving data ...