How to fillet around this edge?
It depends on what you are wanting to get for the outcome. You might try the dome feature and unselect continuous dome and then set your desired height.
Is this a trick question?
Just select the edge. Are you looking for some kind of fillet that you don't see?
Full Round fillet.
If you select edge fillet and make your profile curvature continuous it should work.
The fillet tool works fine, but you have to use a value small enough to avoid interference on the small end (0.90 works, but 1.00 doesn't).
Is full round fillet possible?
I am trying to get rid of flat surface. Let me try dome.
Thanks you for the help, it is coming.
If you try to fillet with greater than about .9mm you get self intersection as shown below:
Thanks. I have this problem often. You have showed the reason.
You can do a surface loft with the edge and a point.
Your image does not seem my file. Problem with my profile is there no symmetry to locate a suitable point.
Yes, so the sketch that made your profile will need some construction lines to locate that point.
Is there any way to extent this temporary axes so that point on this axes may be a suitable one?
So the point would be on a plane in a sketch and intersect the axis, there's no need to extend the axis.
Retrieving data ...