These holes are not in the origin plane but drafted holes. How can I measure this angle by using Measuring tool?
Make sure the section plane is at exactly 45°
This is what I see when using the Measure tool.
Pick face and edge Or edge and edge
Could you tell me what was incorrect in my method?
Check reply by Kelvin above and try that.
Thanks for the help
Kelvin Lamport wrote:
Is there any reason for 45 deg?
I used 45° because that's where the holes are located.You could also offsett the section plane by the exact hole offset.Either way the section plane should be through the centre of the hole otherwise the edge of the hole will be a curve and not a straight line needed for the angle measurement.
Retrieving data ...