AnsweredAssumed Answered

Solidworks 2008, and 2009 drawing standard

Question asked by Nathan Swenson on Jan 6, 2009
Latest reply on Jan 15, 2009 by John Matrishon
I am in the IT department and we have had several of our Solidworks users complain that the drawing standard is set to ISO and metric units. They would like to be ANSI and IPS by default. From what I understand in previous versions of solidworks there was an option on install to set the default standard. I am however not seeing this option in either 2008 or 2009. Does this need to be configured after installation, and if so where can it be found?

Thanks

Outcomes