At which location imagery mirror should be to get the profile differences?
Sorry Maha, that one is a bit difficult to understand. Are you after something like this?
If so, use the locate profile button. then select the point on the profile sketch you wish to follow the path.
If this is the solution you are after, I would recommend making the path the outer edge of where you want the profile first.
I am able to get the profile I want by means of trial and error method but wording in the PM does not make any sense.
If you want to flip the profile upside-down then you use the horizontal axis. If you want to switch it from left to right you use the vertical axis.
How can this be understood?
Does the profile look the same as the horizontal axis as it does without a mirror?
Retrieving data ...