2 Replies Latest reply on Jun 20, 2017 4:18 AM by Ardyanto Syabana

Flow Simulation tab menu

Ardyanto Syabana Jun 19, 2017 2:19 AM

Greetings Solidworks users,
I have a question. After I've changed some parts in assembly, I kept being asked to change the default geometry which I clicked "No". After sometimes, the menu of the Flow Simulation shifted to the picture below.

Why does the menu changes? How do I revert back to original menu since I need to re-run the simulation?

Re: Flow Simulation tab menu

Siavash Khajehhasani Jun 20, 2017 9:49 AM (in response to Ardyanto Syabana)

To Fix this:
Rename the command manager registry in Windows registry as shown below:
To get there type reg edit in start menu, go to Computer\HKEY_CURRENT_USER\Software\SolidWorks\SOLIDWORKS 2017\User Interface\CommandManager
if issue persists, then rename the user interface registry
Like Show 2 Likes(2)

Actions
- Re: Flow Simulation tab menu
  
  Ardyanto Syabana Jun 20, 2017 4:18 AM (in response to Siavash Khajehhasani)
  
  It works. Thank you so much
  
  Like Show 2 Likes(2)
  
  Actions

Go to original post