AnsweredAssumed Answered

Components placed out in infinity

Question asked by Joel Hoksbergen on Jan 5, 2009
Latest reply on Jan 8, 2009 by Joel Hoksbergen

Like • Show 0 Likes0
Comment • 3

I have recently upgraded to SW09, and I find that whenever I place a component from the toolbox by dragging onto the screen, the component is place way out in the middle of nowhere. It looks good on the screen until I rotate the model and can no longer find the component. Anyone else have this problem?

Thanks,
Joel

No one else has this question

Outcomes

3 Replies

1-GFEX8U Jan 7, 2009 12:43 PM
Mark Correct
Correct Answer
You could add Mate references to the parts. Parts will snap/mate in place.
Like • Show 0 Likes0
Actions
1-GFEX8U Jan 7, 2009 12:44 PM
Mark Correct
Correct Answer
You could add Mate references to the parts. Parts will snap/mate in place.
Like • Show 0 Likes0
Actions
- Joel Hoksbergen @ 1-GFEX8U on Jan 8, 2009 5:41 PM
  Mark Correct
  Correct Answer
  This is an option, but I am just talking about dragging into the assembly. It was never a problem with 07, and it is a pain in 09 because the screw/etc. is way out of the window as soon as you rotate it. I have a lot of parts without the mate reference so I would prefer it to drop nicely in the window.
  
  Thanks,
  Joel
  Like • Show 0 Likes0
  Actions

Components placed out in infinity

Outcomes

Related Content

Recommended Content