Is there any way to simulate from an inlet to 2 outlets? Everytime I attempt to use Flow Trajectories, the 2nd lid wouldn't travel to the final lid. Here's the line of direction
Is there any way to simulate from an inlet to 2 outlets? Everytime I attempt to use Flow Trajectories, the 2nd lid wouldn't travel to the final lid. Here's the line of direction
Hi Ardyanto,
If you were to define a flow trajectory plot where all three lid faces were selected then I believe you would see a more complete representation of the floor trajectories coming/going from all the lids.
Does that mean I have to insert Boundary to both of the lid's faces?
I you are just talking about trajectories , there is no need to define two boundry conditions.
You can select many faces for trajectories.
Alright, so I just have to select both faces of the lid for the direction of the flow. Thank you so much
Hi Ardyanto,
If you were to define a flow trajectory plot where all three lid faces were selected then I believe you would see a more complete representation of the floor trajectories coming/going from all the lids.