I'm trying to use zebra stripes to review a fillet. It's a small fillet (1mm), but I still want to see a clean transition. I've increased the 'Stripe Accuracy' without much affect. I have seen some improvement by increasing 'Shaded and draft quality HLR/HLV resolution' in 'Image Quality'. However, this is still the best I've been able to achieve. Are there any other settings or ways to improve this output?
Adam... if you have max out the quality.. then that is as much as you will get,.. afaik.
Okay, thanks! From what I've been reading, it looks like the stripes are mainly for evaluating edge relationships and not surface quality. Does that seem correct to you?
.. it's helping with evaluating smoothness and the transitions/boundaries.... alternately, you can choose a image or reflection map instead of the strips?
..another analysis tool for understand what the surface is doing is Curvature (radius,.. not as good as say, Rhino3D)... or, have both zebra and curvature on at the same time to evalulate?
