Is there any tool in SW to find out the location if this happened?
Is there any tool in SW to find out the location if this happened?
Hi Maha,
another approach is to start a 3D sketch, select all other sketch entities and convert them. If you want to convert this to a single line segment go to Tools>spine tools>fit spline.
EDIT,
Something doesn't like the fit spline function. 3D sketch should give you what you need though.
Is it possible in sketch mode only?
Your problem is in sketch 3. Delete the 5.15 radius and the dim to the end point. Make the rad tangent to the line and the ends coincident.
What do you mean by sketch mode only?
If you exit from sketch mode it is gray.
Yes you need to fit spline from within the 3D sketch, select all the lines you want to join, then apply fit spline.
Thanks
I thought we covered this a couple of weeks ago?
Where are you getting these imaginary dimensions?
In the real world we cannot manufacture beyond 2 or 3 decimal places - so if you see an 8-decimal place driving dimension you are making up imaginary dimensions.
Yep, I found it Dimension in spring
All you had to do was edit my dimensions.
Thanks
Usually I repeat the work I do, there are two reasons for that:
-To remember the work I do.
-To identify new issues that I have missed.
Your problem is in sketch 3. Delete the 5.15 radius and the dim to the end point. Make the rad tangent to the line and the ends coincident.