8 Replies Latest reply on Jun 12, 2017 4:46 PM by Kelly Ramirez

    Is Area Hatch only available for cross-sections?

    Kelly Ramirez

      Hello,

       

      I'm trying to find out if there's a way to apply a hatch in a drawing when the model is not viewed as a cross-section. hatch.jpg

      I don't want to create this drawing in a cross-section view because there are too many lines that make the drawing look too crowded. I know in AutoCAD you just need an enclosed 2D area to hatch. Is something like this possible in Solidworks?

       

      Thanks,

      Kelly