AnsweredAssumed Answered

Motion study of adjustable knife.

Question asked by Pascal Turcotte on Jun 10, 2017
Latest reply on Sep 14, 2017 by Deepak Gupta

Hello guys, hope some of you can answer this, cause i am quite stuck in there...

I want the little piece of metal from the black plastic bracket to bend whenever i screw in or out from the slot. I respectively named the 3 files to open : Open_this_one1  Open_this_One2, Open_this_One3

 

My problem is the follwing : I created a configuration which allows the little metal bracket to flex just about 45 degrees, but when i assembly that to the support, it just pop up a error message. What did i do wrong?

 

Thank you!!

Outcomes