Why does SW give inconsistent flanges? Below is mine and I have tried 3 ways and each method has returned the same incorrect result:
The flange on the left is correct with the correct relief in the corner.
The flange on the right will not generate the same relief.
Methods I have used:
Mirror Extrude Cut & Flange together
Mirror Extrude Cut then Mirror Flange
Mirror Extrude Cut then add a flange
Mirror Extrude Cut then add both flanges together
Add both Extrude Cuts together then add flanges.
I just the relief to be correct on all flanges, not some flanges. Is there any other method of fix for this at all?