AnsweredAssumed Answered

how do I fix this driven dimension in the configuration table?

Question asked by Sarah Dwight on Jun 6, 2017
Latest reply on Jun 8, 2017 by Sarah Dwight

So I got this warning:

"Warning: Dimension D2 is conflicting with its value in configuration 10mm SPLIT KNIFE JAW. Edit feature to resolve the conflict."


But it is not... not in that configuration anyway.

The current configuration KNIFE JAW is wrong. It should read 14.928mm, NOT 17mm. But how do I get SW to redo the math or update the driven dimension in the table?

It reads fine in the sketch.


The configuration NOT KNIFE JAW is also wrong in the table, but not in the sketch.

They are both parent configurations... acting like derived configurations?!?!

How can I fix this?