These two lines are on the same plane. I want to find Intersection point of these two lines. But I couldn’t see any Intersection point add relation. What is the reason?
Don't add any relation, just select the 2 lines and then select the point. I just tried it in SW2015 and it worked fine.
There's no point actually there. If you select the two lines and then select the point tool, it'll place one there.
I tried that way as well but it was not coming.
In that way line became solid line why?
So, I'm not in your version of SW but if you're in the sketch were you want the point, you should just select the two lines and then select the point tool. No lines are added and no lines will switch line types.
Before I was able to see this type of relation, now I couldn’t see it. Is there any way to see what relations are available in your SW?
Here's a pic of 2 separate sketches with points at two intersections.
In my version I couldn’t see any star point only solid line overlapping and relation.
That would be the virtual sharps section
Even virtual sharps section is not showing any relation.
Don't do a relation. If you select the two lines and place a virtual sharp there it'll be to whatever standard you have set. My case was a point
Retrieving data ...