Hi All,

I am currently preparing for my CSWA exam by doing the sample test (attached) but I am having issues with getting  similar mass values to the answers in Part 2

From my interpretation of the question, I am getting a mass of 958.34 g with the required AISI 1020 Steel, instead of the possible answer 939.54

I have also ensured my sketch is fully defined and the origin is situated near the center of the part.

This question is the same as mentioned here ( however this was never resolved - plus being over 3 years old.

Could someone look at my part and see where I am going wrong? 

Thanks,

Oscar