0 Replies Latest reply on Jun 2, 2017 12:49 PM by Andre Schalkwijk

    how to show 'mate controller' animation when changing configurations?

    Andre Schalkwijk

      Hi,

      I have defined a mate controller, including animation option.

      Now, the animation plays correctly when inside the definition page (below pic).

       

      Now, when outside the definition page, in my main assembly, I was expecting to see the animation go when switching from 'position1' to 'position2' (below pic.)

      Is the animation only to be viewed when defining the mate controller?

       

      Rgds,

      Andre

       

      Message was edited by: Andre Schalkwijk