AnsweredAssumed Answered

Guide Curve for Surface Loft does not "intersect section" despite coincident relation

Question asked by Justin Ursaki on May 31, 2017
Latest reply on May 31, 2017 by Christian Chu

When trying to do a surface loft between a sketch and the edge of a surface, as shown below:

 

Capture.PNG

 

SolidWorks tells me that Sketch10 does not intersect the top section (the edge of the surface). The other two guide curves work just fine and give no errors, but Sketch10 is preventing the surface loft. The sketch is coincident to the edge and I am not sure why I am getting this error.

 

Any help would be greatly appreciated. The file is attached.

Attachments

Outcomes