AnsweredAssumed Answered

Wires missing from routing

Question asked by Greg Bosma on May 30, 2017
Latest reply on May 30, 2017 by Greg Bosma

I'm trying to route wires through SW Electrical 3D using an existing schematic. All components have been inserted and associated, so it's just a matter of pressing "Route Wires" to automatically route everything.

 

I've done this, started editing the splines that were generated, and SolidWorks crashed. When I re-opened SolidWorks, the wires were missing. I pressed "Route Wires" again and nothing happened.

 

It's almost as if SolidWorks thinks the wires are already routed, but an error keeps them from appearing in the 3D model.

 

Is there any way to reset this so I can try to re-route the wires?

Outcomes