AnsweredAssumed Answered

problem dimensioning hole on drawing

Question asked by Michael Gera on May 22, 2017
Latest reply on May 23, 2017 by Dan Pihlaja

Attached is a drawing and the supporting part.

 

For some reason, some apparently very strange reason, SolidWorks (2016 SP 4.0) is not letting me put a diameter dimension on the 2.015" dia. hole.  I even tried showing and dimensioning said hole's sketch (even going so far as to use the "sketch" selection filter) and it still won't work.  The only way I was able to dimension the x/y locations was by dimensioning to the 3/4" dia. sketched circle.  Any ideas?

 

The feature of said problem hole is called "vacuum port".

 

Thanks for any help.

Attachments

Outcomes