Have a part created on a perpendicular plane as a rod swept on a flat sketch.
Is there a way to add a bend to this part?
I am aware i can recreate the part with all the bends i want, but trying to avoid that as the part has already been released as bent on one plane only.
Ideas?
I would be nice if we could see the part.
need bend just above small rectangular mounting block. Along the X at @ 5°
Is it for aesthetics only or will it need to be in the final design?? If it's just for aesthetics you could add a configuration....
final design
If it's for final design you would need a change the revision, not? So not sure what you're trying to avoid??
Check out this thread:
The 5th Weekly Power-User Challenge (May 19th, 2017): Straighten an Imported Wire
May have some tips.
Look at the Flex Tool.
Look at the Flex Tool.