Just upgraded to SW2017...How can you move the Rotate Context Toolbar from it's docked position that obscures the triad?
You can grab it and move around.
Yeah....That was the first thing I tried to do before asking the question but I can't grab it.....
Take your pointer over the gray line on that toolbar and then you should be able to grab it and move
Switch up monitor 1 and 2, then it won't cover the triad the next time you go to insert a part into an assy.
Seriously though, how do you pin it to a new location and have it stay there the next time you do this? I run SW on one monitor and it is always showing up on the other monitor every time. Even after moving it!
I've been able to "grab it" once and move it 1 out of 10 times but it'll default to the obscuring location when I move SW to the preferred monitor.
This has been reported under SPR #:1018875
Thank You Sir
So what's the status with this issue? It's been almost a year now since this was reported and it looks like there is still no correct answer. I can only see the rotate context toolbar when using a single monitor. I'm running SW16 SP5, and using a Dell WD15 Dock and Dell Precision 5520 Laptop. Never had an issue prior to the dock setup, but everything else works as it should.
David, this has been fixed in SW2017 SP 4 reported under SPR #:998849.
SPR #:1018875 was a duplicate SPR reported for same issue.
Retrieving data ...