AnsweredAssumed Answered

unable to extrude with angle/draft  a sketch including an equation driven curve

Question asked by Foad Sojoodi Farimani on May 15, 2017
Latest reply on May 15, 2017 by Foad Sojoodi Farimani

I'm trying to make a sinusoidal bevel gear (just because I don't need involute profile), as you can see in the image below:

 

Untitled.png

 

Unfortunately SW can't extrude the sketch with higher angles than 3 degrees, giving me the error you see in the picture :"unable to add the specific draft to the extruded feature. please try a smaller draft angle".

 

I would appreciate if you could help me know how I can solve this issue.

Outcomes