AnsweredAssumed Answered

Showing weld bead full pen fillup of gap in assembly?

Question asked by Dave Krum on May 12, 2017
Latest reply on May 12, 2017 by John Stoltzfus

Good afternoon All,

I'm not that familiar with all the possibilities offered for using the weld bead feature in assemblies but I have a fairly simple part that I'd like to show on a drawing to be given to people taking a weld test that they must pass in ordered to be hired.  Its a simple full-pen weld filling up of gap for 3" of length using a backer bar on the 5" length pieces below.  I am not having luck getting it to show correctly.  Perhaps I'm not picking the correct edges in the correct order or maybe it simply cannot be modeled properly and should only shown on drawing using the simple full-pen v-groove weld symbol with backer bar.  Just curious if this can be done.  Thanks in advance.

 

Attachments

Outcomes