This content has been marked as final. Show 6 replies
OK, I can't find the original thread as I suspect that it has been deleted.
However, someone had a lever that they wanted use as an actuator to alternately actuate two shafts. And they wanted to actuate it with mates and with dragging the lever.
I think that I figured it out. I have attached a video.
In addition, I have attached my assembly.
I know that there is a way to make this more robust, but I ran out of time to spend on this. Maybe someone can look at it and improve on it.
EDIT: Wanted to add that this was done with SW 2015 SP5
Message was edited by: Dan Pihlaja