I need to show the thread or at least different type of hatch for the two studs shown below in section view. How do I do that? Thanks.
I found a trick how to show the stud unhatch. I move the section view as shown and it works!
It should change if you change the Material in the model.
This is the stud I downloaded from supplier website. There is no Edit material when I do right click. Thanks
If you want to customize the hatching, click on the hatch you want to change then you can un-check the box for "Material Crosshatch" and then you can choose whatever you want it to be.
I used SW 2012. I don't know how to get to this window to see this option. When I click on the hatch, on the left hand side all I see are these shown below. How do you get to Area/Hatch Fill option? Thanks
I can't confirm, i'm on 2016, but your properties point to you're clicking on something other than the hatch, more specifically Detail View E. Is this where you're clicking?
That screenshot is from a Detail View. You need to click directly on the hatching in your Section View.
...or de-select "Material crosshatch". Next select what you want the change to apply to in the drop-down immediately below it, and finally select the type.
Retrieving data ...