AnsweredAssumed Answered

why do my cut extrude sketches always blow up after completing cut extrude feature?

Question asked by Johnathon Green on May 9, 2017
Latest reply on May 9, 2017 by Johnathon Green

We constantly have this issue at work and I'm finally attempting to post it...I will place a simple sketch to cut off the excess of a roof part:

 

Capture A.JPG

 

....Then after I complete the cut extrude feature it gives me the following warning and throws my sketch to another part of the structure...usually in some mirrored direction?  my sketches are always fully defined and linked back to a main base sketch.  Capture B.JPG

 

any help would be greatly appreciated!

Outcomes