0 Replies Latest reply on May 3, 2017 2:14 PM by Robert Millot

    Question on In-Use Configuration Drawings and Flat Patterns

    Robert Millot

      Hello,

       

      I recently learned in a previous post that you can set your drawing to show the "In-Use" configuration currently active in your model:

      However, I am having trouble applying this to sheet metal.  Since the flat pattern is a "derived configuration", setting this for a sheet metal part does not allow me to place a flat pattern view of the current configuration (the view reverts to the folded, or "in-use" state, of the model).  Because of this, I have not been able to use configurations in my sheet metal parts.

      Is there any way to overcome this?

       

      Thanks,

      Bob