How to wind wire back on itself, fill spool multiple layers of wire with one helix?
Attach your *.sldprt file here if you can't figure it out.
Sorry I'm new to Solidworks, so the composite curve is used to connect to two "layers" of wires?
I'm making the following wire wound core.
You can't and don't need to use one helix? Why that assumption??
Two layers of wire is two separate helix sketches. there will also need to be a sketch connecting the two.
Each layer of wire will need it's own helix because the direction of the helix changes from layer to layer as well as the diameter of the helix.
You can use the composite curve to combine all of the curves and then sweep or you can simply sweep each layer as you go.
Retrieving data ...