Plane3 is part’s mid plane. Is it possible to move the part towards LHS and coincide plane3 with Right plane? That means making Right plane part’s mid plane.
For an experienced user - the first thing they should do is recognize obvious symmetry and position Sketch1 in a logical position to make use of any obvious symmetry.
If this was somehow neglected - then it might be as simple as editing Sketch1 and moving the sketch to a logical position.
But if the user didn't recognize this right from the start - they probably built their model with dependencies that make a simple and trivial sketch move into something that requires a lot of repair.
I recommend rebuilding the part as a "lesson learned" - in the future pay attention to symmetry in design.
Do that a few times and you will not forget this lesson.
But if your assignment is due in 10 minutes - you could use the Move Body command (you might Customize to add this to your ribbon).
This is particularly useful when working with imported geometry or someone else's work.
Thank you for the help.
Retrieving data ...