6 Replies Latest reply on May 1, 2017 1:02 AM by Dennis Bacon

    Issues thickening surface

    B. Meyer

      Hi,

      I am new to surfacing and am trying to learn by re-modeling an Xbox controller (see attached). I have a basic surface model down, but am running into issues when I try to thicken.

       

      Since I haven't done this before, I'm not quite sure where to start for fixing this. Could anyone recommend some general guidelines for diagnosing where the issue is in my part? Or if you're feeling really nice, could anyone even take a look at my part and give a specific recommendation?

       

      Thank you very much for the help,

      B